Home → Frankston South → EV Charger Installation
EV Charger Installation in Frankston South from Impulse Electrical Contractors, based nearby in Dromana and servicing the wider Mornington Peninsula. Around the elevated bayside streets, the local shops and the coastal outlook over the bay, brick veneer family homes, elevated bayside properties, architect-designed rebuilds and renovated extensions need electrical work that is safe, tidy and suited to local conditions.
Call 0418 383 232A home charger in Frankston South starts with the original board, not the car. Brick veneer family homes often have no spare way and a supply that was never asked to run a dedicated charging circuit. A garage on an established house can be straightforward once capacity is confirmed. A charger added during a renovation only goes ahead if the new circuits and the charger can share that supply. Impulse Electrical installs the dedicated circuit and the wall unit from our Dromana base.
Home EV charging is faster, safer and more convenient than relying on a standard power point or public chargers. Impulse Electrical installs dedicated EV charger circuits, wall-mounted charging units and load-managed charging where needed. We assess your switchboard, cable route, parking location and available capacity before fitting a charger that suits your vehicle and daily routine. In Frankston South, original boards often have no spare capacity for a charger, so a properly wired home circuit means the car can charge overnight without sharing a general power point. Impulse Electrical is fully licensed — A Grade A53308 and REC 25266 — with $25M public liability and a Certificate of Electrical Safety supplied on every job.
We look at the switchboard, the cable route to where the car actually stands, and whether a renovation has already used the spare ways. You get a tested circuit, a labelled breaker and a COES. Call 0418 383 232.
On an original house the work is a dedicated circuit from the switchboard to a wall-mounted charger in the garage or carport, with load management if the supply cannot run the charger at the same time as the rest of the house. If the enclosure is still a fuse board, the charger waits until that board is replaced. On a renovation we count the charger with the kitchen and the extension, so the new board is sized once rather than twice.
Frankston South already lists EV charger installation among the local services, and it lists original switchboards as the common problem. Those two facts meet in the garage. A charger hung off a fuse board is not an installation. A charger added after a new kitchen, without looking at what the renovation used, is the same mistake. We say which it is after opening the board.
Related reading: EV charger installation across the Peninsula · EV charger installation guide · Electrician Frankston South
Also serving: Frankston,Mount Eliza,Karingal,Langwarrin
Often yes, after the board is checked. If there is no spare way, or the board is still fuses, the switchboard is upgraded as part of the same job. We do not hang a charger off a fuse board.
Yes. It should be counted with the new kitchen and extension circuits so the board is sized for all of them. Adding it later, onto whatever ways are left, is how a new board fills up immediately.
No. A charger gets its own circuit. Existing garage outlets stay on their own protection. If that garage circuit has no safety switch, we fix that while we are in the board.
No. We check what is actually at the meter. The charger is planned for the supply that is there. If the board cannot take it, we say so before any cable is run.
