Home → Arthurs Seat → Ceiling Fan Installation
Ceiling Fan Installation in Arthurs Seat from Impulse Electrical Contractors, based in Dromana at the foot of the Seat. Hillside homes along Arthurs Seat Road sit above the bay, with the State Park, the Eagle chairlift and tourism businesses at the top.
Call 0418 383 232Ceiling fans at Arthurs Seat go into hillside houses along Arthurs Seat Road. The ceiling has to hold the fan, and the circuit has to be able to take it. Wind on this escarpment is an outdoor-fitting problem. It is not a reason to skip the mounting check indoors. Impulse Electrical installs the fan and the wiring from our Dromana base.
We confirm the mounting point, the switch or remote, and whether the existing circuit can take the fan. An older ceiling is checked before anything is hung. A long cable run from the street does not get an extra load until the board has been looked at. Call 0418 383 232.
The ceiling structure is checked first, including in houses where the original fixing was never meant for a fan. Indoor fans, including DC and remote-control models, are wired and tested. On a raked ceiling, common where the house follows the slope, the mount is chosen for that pitch.
Exposed positions on the Seat cop wind and weather, which is why outdoor fittings here are IP-rated. A ceiling fan is an indoor job. The same house can still need that outdoor gear on a deck or an outbuilding, and that is a separate fitting from the fan. The board is checked if either one needs a new circuit.
Houses that step down the escarpment often have a raked ceiling that follows the slope. The mount has to suit that pitch, and the fixing has to be in a part of the ceiling that can hold the fan. Wind on the Seat is the reason outdoor fittings are IP-rated. It is not a reason to hang an indoor fan without looking at the structure. A deck fan, if one is asked for, is that outdoor fitting, weather-resistant and fixed so it stays put. The indoor fan and the deck fitting are not the same circuit by default. Both wait if the board at the end of a long street run has no spare way.
Related reading: Ceiling fan installation · Ceiling fan installation guide · Electrician Arthurs Seat
Also serving: Dromana, Red Hill, McCrae, Balnarring
Only after the structure is checked. Houses that follow the hillside often have a pitch the original ceiling was not built to hang a fan from. The mount matches that pitch.
The wind changes outdoor fittings, which are IP-rated for exposed sites. The indoor fan still needs a sound mounting and a circuit that can carry it.
Only after that board and the run are checked. A hillside supply that is already stretched does not get another load by default.
No. A fan is a lighter load. A split system needs its own circuit and a board check. We do not treat one as the other.
